Cloos NexT 452 AC, Руководство по эксплуатации

Страница: 140 / 234

140
Configuration menu
5.9 QWD
Wire by hand
Configuration "from
Job"
The adjusted wire speed in the job determines
the speed for the manual wire feed.
Configuration "Set
value"
The adjusted set value determines the speed
for the manual wire feed.
5.9.1 QWD PushPull
In this menu you configure which PushPull drive is connected to which
wire drive (QWD1 ... QWD4).
• No drive
• Cloos Arcette
• Cloos Arcette 2
• Binzel PP+401D
• TBI PPP 7G/7W
• Dinse DIX MPZ 304
• Not defined
Blocked drives will be displayed in red in the selection. These drives may be
activated optionally.
5.9.2 Wire end control
In this menu, the signal transmitter for wire end control is selected for the
maximum of 4 possible wire feed distances.
Function Description
Automatic*
1
Welding power source recognises the devic-
es connected and automatically selects the
wire drive unit nearest to the wire storage
to be the signal transmitter.
QWD contact sensor / ring
sensor*
2
Welding power source waits for the selected
sensor signal from QWD-A.
QWDBx_1 contact sensor /
ring sensor*
2
Welding power source waits for the selected
sensor signal from QWD-B.
QWDBx_2 contact sensor /
ring sensor*
2
Welding power source waits for the selected
sensor signal from an additional QWD-B
"x_2" connected in series with a QWD-B
"x_1".
5.10 Locking/unlocking functions
The scope of the functions of the operating module can be restricted on
several levels.
Locking functions
To activate the restrictions, press the "Key" button until the key symbol
appears at the top of the screen.
* 1
Applicable if the wire drives
involved are equipped with a key
switch or with a pre-assembled
jumper for selecting the signal
transmitter for wire monitoring.
* 2
Required if configuration by
means of a key switch or pre-as-
sembled jumper is not possible.
Key button to lock and
unlock the operating
module
Locking symbol