CLIVET WSAT-YES FC, Руководство пользователя, Страница: 8 / 86

 Be aware that refrigerants are odourless.
 Place the unit on the ground.
 The earth resistance should comply with the law and local
regulations.
 Do not connect the earth cable to gas or water mains,
lightning rods or phone earth cables.
 Incomplete earthing may cause electrical shocks.

Gas mains: fires or explosions may occur in case of a gas
leak.

Water mains: rigid vinyl tubes are not effective.

Lightning rods or phone earth cables: the electrical threshold
can increase abnormally if hit by lightning.
 Install the power supply cable at least one metre from TVs or
radios to prevent interferences or disturbances. Depending on
the type of radio wave, one metre may not be enough to
avoid disturbances.
 Do not wash the unit as it may cause electric shocks or fires.

If the power supply cable is damaged, it must be replaced by
the producers, personnel from its assistance network or
qualified personnel.
 Do not install the unit in the following places:

Where there is mineral oil, even in form of vapour. Plastic
parts may deteriorate, disperse and cause water leaks.

Where corrosive gases (such as sulphurous acid) are
produced.

Where the corrosion of copper pipes or welded parts may
cause refrigerant leaks.

Where there are devices emitting electromagnetic waves.
Electromagnetic waves may disturb the control system and
cause malfunctions.
 Where flammable gases may leak, or carbon fibre or
flammable powers may be found in the air or where volatile
flammable materials such as paint thinners or petrol are
handled. These gases may cause a fire.
 Where the air contains high levels of salt, such as the
seaside.

Where the power supply voltage is subject to fluctuations,
such as in factories.

On vehicles or ships.

Where there are acid or alkaline vapours.
 Prior to installation, verify if the user’s power supply meets the
unit’s installation requirements (including reliable earthing,
differential circuit-breaker, component size, wire section, etc.). If
the electrical installation requirements are not met, the unit
cannot be installed until the electrical system is rectified.
 Before the hydraulic connection and electrical wiring
operations, verify that the installation area is safe and without
hidden dangers such as water, electricity and gas conduits.
CAUTION
 Do not touch the fins of the heat exchanger as they may
cause injury.