Clavister NetWall W20A, Руководство по началу работы

Страница: 25 / 89

Network Connection Setup
For setting up access across a network using the Web Interface or the CLI via SSH, it is necessary
to connect an Ethernet interface on an external management computer to the default
management Ethernet interface on the W20B.
The default management Ethernet interface for the W20B is G1 and this is assigned the default
IPv4 address of 192.168.1.1 by cOS Core. This interface should be connected to the same
network as the management computer (or a network accessible from the management
computer via one or more switches).
Typically, the connection between the management computer and the default management
interface is made via a switch using standard Ethernet cables, as shown in the illustration below.
For connection to the public Internet, another W20B Ethernet interface should be connected to
an ISP. In the cOS Core setup wizard this is referred to as the
WAN interface. In this guide, it is
assumed that the G2 interface of the W20B is used for Internet connection, although any other
available interface could be used instead.
Direct Network Connection to the Firewall's Management Interface
Connection to the default management interface G1 on the firewall from the management
computer can be done directly without using switch hardware. This could be done using a
crossover cable. However, all the RJ45 interfaces on the W20B support
Automatic MDI-X and a
crossover cable is not necessary with them.
Management Computer Ethernet Interface Setup
Traffic will be able to flow between the designated management computer interface and the
Clavister Next Generation Firewall interface because they are on the same IP network. This means
the management computer interface should be first assigned the following static IPv4 addresses:
• IP address: 192.168.1.30
• Subnet mask: 255.255.255.0
• Default gateway: 192.168.1.1
Chapter 3: W20B Installation
25