<SM-431049>
− 23 −
５．５
Installation of Transfers
１） For table type, flatness of the work piece surface which is to be mounted to the table or end plate
must be 0.02mm or less, and the product must not be subjected to bending, twisting, and such.
Otherwise, it may cause the product to break down.
２） The bolt screw length and tightening torque when installing jigs to the slide table and end plate must
follow the values below.
３） When installing to the slide table surface and end plate surface, take careful note of moment load.
For details, refer to the pages in the catalog that explain model selection.
[Allowable Moment Load at Rest]
Derive MʼT from the values derived for M1ʼ, M2ʼ, M3ʼ, Wʼ in the figure below and based on the
chart below. (G: Setting Acceleration m/s
2
)
Make sure the value for MʼT is less than 1 as indicated above.
Installation to the Slide Table Surface
Bolt in use
Tightening
Torque
（N・m）
Maximum
Screw Depth
L（㎜）
ＥＬＣＲ-
□28／□42
M5×0.8
2.9
5
Installation to the Slide Table Surface
Bolt in use
Tightening
Torque
（N・m）
Maximum
Screw Depth
L（㎜）
ＥＬＣＲ-□28
9
ＥＬＣＲ-□42
11
2.9
M5×0.8
Stroke Length
Vertical Load
Bending Moment
Radial Moment
Twist Moment
(mm)
W'(max) (N)
Ｍ１ʼ（max) （Ｎ・ｍ） Ｍ２ʼ（max) （Ｎ・ｍ） Ｍ３ʼ（max) （Ｎ・ｍ）
50
17.8
17.8
100
37.3
37.3
50
31.1
31.1
100 、 150
56.2
56.2
ＥＬＣＲ
-28
380.8
19.2
ＥＬＣＲ
-42
548.8
37.6
Содержание ELCR Series
Страница 56: ...MEMO...
