CITROEN Berlingo 2003, Руководство пользователя

Страница: 308 / 482

304
CLUTCH
GEARBOX
DRIVESHAFTS
MB3 AUTOMATIC GEARBOX CONTROLS - CHECKS AND ADJUSTMENTS
Selection control Adjusting the selection control
- Turn forwards by 1/4 turn, remove the gear lever knob (2) .
Refitting the gear lever knob.
- Press and hold down the locking button (3) .
- Fit the knob (2) on the lever until it touches its stop
(in the direction shown in the diagram).
- Release the locking button (3) .
- Turn forwards by 1/4 turn.
- Refit the screws
(1) .
ESSENTIAL : Check the passage of all the gears, otherwise adjust
the selection control
.
WARNING: No part must be forced
while performing these operations
(careful removal).
Removing the gear lever knob.
- Remove the screws (1).
- Lift the lever knob (2) by about 10mm.
- Turn backwards by 1/4 turn, and
raise by approximately
7mm.
- Press and hold down the locking
button
(3)
ESSENTIAL : Put the gearbox side
control in the 1st imposed position;
the 2 markings «a» must be aligned.
- Fit the ball joint (1).
- Fit the lug (2).
- Lock the outer cable stop by 1/4 turn
(in the direction of the arrow).
- Check that the painted markings
«b»
are aligned.
B2CP18YC B2CP18WC B2CP18XC
SAXO