Cisco UCS C890 M5, Инструкция по эксплуатации

Страница: 38 / 191

Contents Page 39
3. The two rail sections are screwed together to keep them immobile during
shipping. Release these screws just enough to allow the rails to slide apart. Note
the arrow on the rail, which indicates the end that attaches to the front of the
rack.
4. Slide the rails apart far enough to match the depth of the rack. Position the rails
with the template and secure the front of each to the front of the rack with two
flathead screws, then secure the back of each rail to the rear of the rack with two
flathead screws. Note that the rails are left/right specific and very heavy.
5. (Optional step) Add the front left and right handles to the chassis using five screws
to secure each handle. Install a thumbscrew through the bottom hole of each
handle.
Note: These handles are optional and need only be installed when mounting the
system into a short rack. When mounting into a deep rack, they are unnecessary and
regular screws should be used instead of thumbscrews.
Be aware that these handles are not to be used for lifting the system, they are only to
be used to slide the system within the rack.
6. With one person on either side (see the descriptive label on the side of the chassis),
lift the system and slide it into the installed rails.