Cisco UCS C890 M5, Инструкция по эксплуатации

Страница: 126 / 191

131
Contents Page 131
sSATA Device Type
Use this feature to specify if the device installed on the sSATA port specified by the user
should be connected to a Solid-State drive or a Hard Disk Drive. The options are
Hard
Disk Drive and Solid-State Drive.
PCIe/PCI/PnP Configuration
Note: PCIe/PCI/PnP Configuration settings may differ depending on the PCI-E devices
installed on the motherboard.
The following PCI information will be displayed:
•
PCI Bus Driver Version
•
PCI Devices Common Settings
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address. The
options are Enabled and Disabled.
SR-IOV Support (Available if the system supports Single-Root Virtualization)
Select Enabled for Single-Root IO Virtualization support. The options are Enabled and
Disabled.
MMIOHBase
Use this feature to select the base memory size according to memory-address mapping for the
IO hub. The base memory size must be between 4032G to 4078G. The options are 56T , 40T,
24T, 16T, 4T, and 1T.
MMIO High Granularity Size
Use this feature to select the high memory size according to memory-address mapping for the
IO hub. The options are 1G, 4G, 16G, 64G, 256G , and 1024G.
Maximum Read Request
Select Auto for the system BIOS to automatically set the maximum size for a read request for
a PCI-E device to enhance system performance. The options are Auto , 128 Bytes, 256 Bytes,
512 Bytes, 1024 Bytes, 2048 Bytes, and 4096 Bytes.
MMCFG Base
This feature determines how the lowest MMCFG (Memory-Mapped Configuration) base is
assigned to onboard PCI devices. The options are 1G, 1.5G, 1.75G. 2G , 2.25G, and 3G.