42
For security reasons, it is highly recommended that you change the password for
the root user.
** Please enter a valid password for root user as per the requirements below! **
Changing password for user root.
You can now choose the new password.
A valid password should be a mix of upper and lower case letters,
digits, and other characters. Minimum of 8 characters and maximum
of 16 characters with characters from all of these classes. Minimum
of 2 characters from each of the four character classes is mandatory.
An upper case letter that begins the password and a digit that ends
it do not count towards the number of character classes used.
Enter new password:
Re-type new password:
passwd: all authentication tokens updated successfully.
Step 21
Type the
admin
user password for the CAS direct access web console (from field
m.
). The CAS
web console provides limited CAS-specific settings, and is primarily used to set up High
Availability.
Please enter an appropriately secure password for the web console admin user.
New password for web console admin:
Confirm new password for web console admin:
Step 22
After the configuration is complete, press Enter to reboot the CAS.
Configuration is complete.
Changes require a REBOOT of Clean Access Server.
Step 23
Enter the following command to reboot the CAS after configuration is complete:
#
reboot
The CAS initial configuration is now complete.
Step 24
Test the installation:
a.
Ping the eth0 interface address from a command line. If working properly, the interface should
respond to the ping.
b.
If the CAS is not responding, try connecting to the CAS using SSH (Secure Shell). Connect
with the
root
username and password. Once connected, try pinging the gateway and/or an
external website from the CAS to see if the CAS can reach the external network.
If both tests fail, make sure that you have configured the IP address correctly and that the
other network settings are correct.
