37
b.
If the CAM does not respond, try connecting to the CAM using SSH (Secure Shell). Connect
with the
root
username and password. Once connected, try pinging the default gateway to
see if the CAM can reach the external network.
If both tests fail, make sure that you have configured the IP address correctly and that the
other network settings are correct.
If after installation you need to reset the initial configuration settings for the CAM, connect
to the CAM machine directly or through SSH and use the CLI command
service perfigo
config
.
Once the CAM is configured, you will be able to access the CAM web console to add product
licenses, and add initially configured Clean Access Servers to the CAM for management and
further configuration, as described in Accessing the CAM Web Console, page 45.
Step 17
Continue to Run CAS Configuration Utility Script, page 37 to initially configure your Clean
Access Servers.
Run CAS Configuration Utility Script
Step 1
A
fter the software is installed from the CD and package installation is complete, the welcome
script for the configuration utility appears
:
Welcome to the Cisco Clean Access Manager quick configuration utility.
Note that you need to be root to execute this utility.
The utility will now ask you a series of configuration questions.
Please answer them carefully.
Cisco Clean Access Manager, (C) 2008 Cisco Systems, Inc.
Note
If this prompt does not appear after you install the Cisco NAC Appliance software and restart
the CAS, refer to Manually Restarting the Configuration Utility, page 44.
Step 2
When prompted, type an IP address for the eth0 (trusted) interface of the CAS (from field
a.
of the CAS Worksheet) and press Enter. Confirm the value when prompted, or type
n
and press
Enter to correct the entry.
Configuring the network interfaces:
Please enter the IP address for the interface eth0 []: 10.201.240.100
You entered 10.201.240.100 Is this correct? (y/n)? [y]
Note
The eth0 IP address of the CAS is the same as the Management IP address.
