Cisco ME 3600X, Справочник по командам

Страница: 21 / 628

1-3
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 1 Using the Command-Line Interface
CLI Command Modes
Privileged EXEC Mode
Because many of the privileged commands configure operating parameters, privileged access should be
password-protected to prevent unauthorized use. The privileged command set includes those commands
contained in user EXEC mode, as well as the
configure privileged EXEC command through which you
access the remaining command modes.
If your system administrator has set a password, you are prompted to enter it before being granted access
to privileged EXEC mode. The password does not appear on the screen and is case sensitive.
The privileged EXEC mode prompt is the device name followed by the pound sign (
#
).
Switch#
Enter the enable command to access privileged EXEC mode:
Switch>
enable
Switch#
The supported commands can vary depending on the version of software in use. To display a
comprehensive list of commands, enter a question mark (
? ) at the prompt.
Switch# ?
To return to user EXEC mode, enter the disable privileged EXEC command.
Global Configuration Mode
Global configuration commands apply to features that affect the device as a whole. Use the configure
privileged EXEC command to enter global configuration mode. The default is to enter commands from
the management console.
When you enter the configure command, a message prompts you for the source of the configuration
commands:
Switch# configure
Configuring from terminal, memory, or network [terminal]?
You can specify either the terminal or nonvolatile RAM (NVRAM) as the source of configuration
commands.
This example shows you how to access global configuration mode:
Switch#
configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
The supported commands can vary depending on the version of software in use. To display a
comprehensive list of commands, enter a question mark (
? ) at the prompt.
Switch(config)# ?
To exit global configuration command mode and to return to privileged EXEC mode, enter the end or
exit command, or press Ctrl-Z .