Install USB Drivers
68-4004214-01 Rev D
23
Install USB Drivers
This section contains instructions for installing the cable modem gateway USB
drivers if your PC is equipped with a USB interface and a Microsoft Windows 2000
or Windows XP operating system. The USB driver installation procedures are
different for each operating system. Follow the appropriate instructions in this
section for your operating system.
Note:
If your PC does not have a USB interface, you may skip this section.
Installing USB Drivers on Windows 2000 Systems
1
Insert the
USB Cable Modem Driver Installation Disk
into the CD-ROM drive
of your PC.
2
Wait until the
POWER
and
ONLINE
LED status indicators on the front panel of
the cable modem gateway illuminate solid green.
3
Click
Next
in the Found New Hardware Wizard window.
4
Select
Search for a suitable driver for my device (recommended)
in the Found
New Hardware Wizard window, and then click
Next
.
5
Select
CD-ROM drives
in the Found New Hardware Wizard window, and then
click
Next
.
6
Click
Next
in the Found New Hardware Wizard window. The system searches
for the driver file for your hardware device.
7
After the system finds the USB driver, the Digital Signature Not Found window
opens and displays a confirmation message to continue the installation.
8
Click
Yes
to continue the installation. The Found New Hardware Wizard
window reopens with a message that the installation is complete.
9
Click
Finish
to close the Found New Hardware Wizard window. The USB
drivers are installed on your PC, and your USB devices are ready for use.
10
Try to access the Internet. If you cannot access the Internet, go to
Having
Difficulty?
(on page 134). If you still cannot access the Internet, contact your
service provider for further assistance.
Installing USB Drivers on Windows XP Systems
1
Insert the
USB Cable Modem Driver Installation Disk
into the CD-ROM drive
of your PC.
2
Wait until the
POWER
and
ONLINE
LED status indicators on the front panel of
the cable modem gateway illuminate solid green.
3
Select
Install from a list or specific location (Advanced)
in the Found New
Hardware Wizard window, and then click
Next
.
4
Select
Search removable media (floppy, CD-ROM)
in the Found New
Hardware Wizard window, and then click
Next
.