C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
Software Package Management Commands on Cisco IOS XR Software
install deactivate
SMR-361
Cisco ASR 14000 Series Router System Management Command Reference
OL-17231-01
install deactivate
To remove a package from the active software set, use the
install deactivate
command in EXEC or
administration EXEC mode.
Administration EXEC Mode
install
deactivate
device
:
package
[
auto-abort-timer
minutes
] [
sdr
OWNER
] [
location
node-id
]
[
asynchronous
|
synchronous
] [
parallel-reload
] [
prompt-level
{
default
|
none
}] [
test
]
EXEC Mode
install
deactivate
device
:
package
[
auto-abort-timer
minutes
] [
location
node-id
] [
asynchronous
|
synchronous
] [
parallel-reload
] [
prompt-level
{
default
|
none
}] [
test
]
Syntax Description
device
:
package
Device and package, expressed in concatenated form
(
for example,
disk0:asr14k-mgbl-3.7.1). For the
device
argument, the value is a
specified storage device, typically
disk0:
.
Press
?
after a partial package name to display all possible matches
available for activation. If there is only one match, press [TAB] to fill in
the rest of the package name.
auto-abort-timer
time
(Optional) Specifies an abort timer value,
time
, in minutes, which when
expired loads the last commited loadpath.
sdr
OWNER
(Optional. Administration EXEC mode only) Deactivates a package for
a specific secure domain router (SDR).The only SDR available is
OWNER
, which refers to the entire Cisco ASR 14000 Series Router
router.
location
node-id
(Optional) Deactivates a package from the designated node. The
node-id
argument is entered in
rack
/
slot
/
module
notation.
Note
In most cases, a package cannot be deactivated from a node,
because some version of that package must be running on all
supported nodes after the deactivation operation finishes.
asynchronous
(Optional) Performs the command in asynchronous mode. In
asynchronous mode, this command runs in the background, and the
EXEC prompt is returned as soon as possible. This is the default mode.
synchronous
(Optional) Performs the command in synchronous mode. This mode
allows the installation process to finish before the prompt is returned.
parallel-reload
(Optional) Forces all cards on the router to reload at the same time and
then come up with the new software, rather than proceeding according
to the option encoded in the install package.
prompt-level
{
default
|
none
}
(Optional) Specifies when you are prompted for input during the
procedure.
•
default
—you are prompted only when input is required by the
operation.
•
none
—you are never prompted.
test
(Optional) Verifies the effects of proposed operations without making
changes to the Cisco IOS XR software.
