VCC-2CXP6M
Rev.905-0186-02
©2019 CIS Corporation. All rights reserved.
22
5.19.
Black Level Adjustment
□
This is the function to adjust black level of image sensor.
[Note]
This function is not the function to set the absolute value of black level.
This function can change the black level settings of the image sensor relatively.
This value is 12bit converted. In case of 10bit, the value shall be equivalent to ±16, and in case of
8bit, the value shall be equivalent to ±4.
Settings can be changed while capturing images. However, image may be distorted.
5.20.
Image Quality Selection Mode
□
This is to select image quality of output image.
Image Quality Mode: Image quality selection mode
StandardMode: Standard mode
LowNoiseMode: SN shall be improved compared to StandardMode, however the sensitivity shall be
decreased.
LowFrameRateMode: SN shall be improved more compared to LowNoiseMode, however the frame rate
and the sensitivity shall be decreased. Valid only at Mono8.
5.21.
Defective Pixels Correction
□
This is the function to detect and correct the defective pixels in the data output from the sensor.
□
Data are categorized into two types and controlled.
・
Data at Ex-Factory
The detected data of white pixel defects and black pixel defects at Ex-Factory are saved.
Basically, these data cannot be erased.
・
Data registered by users
Data increased after shipment or the one registered by users.
These data can be entirely erased anytime by DefectPixelDefault.
□
The number of data registerable by users is 128 points. (Note: Up to 32 points per CH.)
AnalogControl
BlackOffset
-64~63
AnalogControl
Image Quality Mode
StandardMode
LowNoiseMode
LowFrameRateMode
