VCC-2CXP6M
Rev.905-0186-02
©2019 CIS Corporation. All rights reserved.
24
□
Defective pixels detection registered by user
This is to detect and register the correction data of white defect caused by the image sensor.
AnalogControl
DefectDetectionThesholdValue
0~4095
DefectDetection
(Execute)
DefectDetectionStatus
(ReadOnly)
DefectPixelDefault
(Execute)
DefectCorrectMode
Reacquire/Add
DefectDetectionThesholdValue: This is to set the threshold value (0~4095: 12bit equivalent) of defective pixels
detection registered by user. The data with luminance level more than the specified level here shall be
registered.
※ 16times more value of the image signal level shall be specified as the threshold value with 8bit images.
DefectDetection: This is to detect the defective pixels registered by user.
This is the function to register the pixels automatically if a pixel exceeds the level specified at
DefectDetectionThresholdValue. Please be noted that no lights should be in the sensor surface to use this
function.
The defective pixels correction registered by user shall be reflected right after the execution.
In case UserSetSave is executed after defective pixels detection registered by user, the data will be saved in
non-volatile memory.
DefectDetectionStatus: This is to indicate the result of the defective pixels correction detection
registered by user.
If the 129 points or more is indicated, please check the threshold value (DefectDetectionThesholdValue) of
defective pixels detection registered by user is correct.
※Please note that the error indication may appear in decimal depends on frame grabber board to use.
DefectPixelDefault: This is to delete entire defective pixels correction data registered by user.
DefectCorrectMode: This is to set the detection mode of defective pixels.
・
In case Reacquire is selected, other than defective pixel added by one point addition
shall be deleted, and reacquire the defective point again.
・
In case Add is selected, the defect point is additionally acquired for the current defect point.
[Note]
Correction data shall be acquired only when the camera is in operation. When camera is not outputting
anything, white defect detection cannot be performed.
When detecting defects, partial scan, binning mode, and shading shall be OFF. (Size shall be set to 1632 x
1248)
When changing the threshold value of DefectDetectionThresholdValue and acquiring the defective pixels
correction data, please execute DefectPixelDefault and delete the defective pixels correction data
registered by user to reacquire it.
0
None defective pixels correction data registered by user
Value (128 or less) When operating correctly (Detected number of defective pixels registered
by user)
0x000e0001(917505) Defective pixels correction data exceeds the maximum number (128
points) registerable.
0x000e0002(917506) Defective pixels correction data exceeds the maximum number (32 points)
registerable in one CH.
