Step 2
–
Microcomputer’s socket
Microcomputer’s socket is also soldered at the back of the
MAKERbuino board.
Be careful how you rotate the socket because
it’s
not symmetrical. Be
sure to place it on the right side indicated by a notch on the socket
pro tip: first solder the two diagonal pins of the
socket, then make sure that the socket is aligned
with the board nicely, correct the alignment if
needed and solder the rest of the pins.
Step 3
–
10k ohm resistor
Find the tiny
10kΩ
resistor (colors: brown, black, black, red,
brown) and solder it to the front side of the board where the
R2 mark is (bottom side of the board)
–
this resistor is
necessary for the screen to work.
