Cineversum Force one, Руководство пользователя

Страница: 10 / 100

2.0 INSTALLATION GUIDELINES
10 R599790 - FORCE Series User Manual
NOTE: Voltage and current requirements are listed on the license label, located at the back of the projector.
2.5 Powering Up
After the AC Power has been switched on, the LCD display above the keypad indicates “Please wait” and the 4 LED
status indicators on the top cover window switch on to amber. These indicate that the projector is changing its state
from powered down to standby. The message “Standby Mode” appears in the display when the projector has
completed its initialization and is ready for power up. The 2 lamp status LEDs will go off to indicate that the lamps
are off. The Power status LED will show amber, indicating that the projector is in standby mode. The shutter LED will
display amber, indicating the shutter is closed. Press and hold the power button on the keypad or remote for 2
seconds, or press twice quickly. The lamps will power on and the fans will come on.
2.6 Connecting a Source
Located at the back of the projector is the input panel where all source connections are made. Each input is labeled
for easy identification. Depending on the type of option card installed, connect your source using the appropriate
cable(s), as follows:
• Analog Input Card, connect 3-, 4-, or 5-wire RGB source to Red/Pr, Green/Y, Blue/Pb, H/C and V using 3, 4 or 5
BNC connectors as required.
• Dual Link DVI Input Card, connect a single or dual DVI video signal to the DVI-I connector, an analog video
signal to the DVI-I connector or an analog video signal to the VGA connector. The DVI signal may contain HDCP
(High-Bandwidth Digital Content Protection).
• Twin HDMI Input Card, connect HDMI (High-Definition Multimedia Interface) cable to one of the two inputs, 1-IN
or 2-IN.
• Dual SD/HD - SDI Input Card, connect SDI (Serial Digital Interface) cable to one of the two inputs, 1-IN or 2-IN.
Both standard-definition (SD) and high-definition (HD) signals are accepted and automatically recognized on
either input.
• Standard Video Card, depending on the source you can apply the following:
1) Composite video source to 1-CVBS, using a BNC Cable
2) A component signal on Inputs 4(Pr), 5(Y), 6(Pb) using BNC Connectors.
3) S-Video to one of the two, 2-SVID or 3-SVID using S-Video cable.
IMPORTANT
Connect the projector's line cord to the AC receptacle at the AC inlet of the projector, then push the wire clip over the
plug to retain it. This prevents the line cord from inadvertent disconnection. Plug the 3-pronged plug end into a
suitably rated grounded AC receptacle. Switch the projector ON. The switch is located just above the AC receptacle.
Do not attempt operation if the AC supply and cord is not within the specified ratings. On power down, wait
5-10 minutes for the fans to turn OFF before unplugging the projector. Always switch off the projector before
unplugging the AC line cord..
The default settings for the projector are to perform a lens calibration after the insertion of a new lens. If this
is the first time the projector has been powered up with the lens, expect a short period (about 15 seconds)
where the lens will move slightly.