Cineversum Force one, Руководство пользователя

Страница: 59 / 100

8.0 ADJUSTING THE IMAGE
R599790 - FORCE Series User Manual 59
Output2. Selecting Disable will shut off the HDMI outputs completely.
• Fade to Black Time
This control sets the amount of time (in seconds) that it takes to fade the image to/from black. NOTE: The OSD only
allows the fade time to be set. To initiate a Fade to Black, the Serial command should be used.
Lens Settings
• Intelligent Lens System
Check this box to enable the Intelligent Lens System (ILS). When enabled, the lens position (horizontal, vertical,
focus, and zoom offsets) are stored per channel. If you change channels, the lens position will change as the new
signal is being displayed.When ILS is not enabled, the lens is controlled independently of channels or input signals.
• Manual Zoom and Focus
When this control is selected, the holding current is removed from the zoom and focus motors so that they can be
changed manually.
NOTE: Zoom and Focus should not be adjusted manually when this control is not selected, as this will result in
damage to the motors.
• Calibrate
The lens calibration procedure is needed each time a new lens is installed in order for the ILS feature to perform
reliably. This procedure calibrates; horizontal, vertical, focus, and zoom offset movements.
• Lock all Lens Motors
Select this check box to prevent all lens motors from moving. It will disable the Zoom, Focus, Horizontal and Vertical
Position settings, effectively locking out any changes and overriding all other lens features. This feature is
particularly useful to prevent accidental lens position changes in multi-projector installations.
• Calibrate on new Lens
Check this box to prompt for a lens calibration each time a lens is inserted. The user will always be prompted before
starting the calibration.
• Calibrate on Startup
Check this box to initiate a ‘Lens Reset’ procedure on every power-up. This is useful if the lens is subject to manual
movement between power sessions.
• Home Position
Return the lens to the horizontal and vertical home position. Focus and zoom are unaffected.
• Calibration Status
This control displays the current lens calibration status.
Power Management
• LCD Backlight
The backlight for the LCD has 3 states. Always On, Always Off, or Timer. The backlight will turn on again when any
key on the LCD is pressed or if an alarm is raised.
• LCD Backlight Timer
Set how long the LCD backlight stays on (in seconds) when in timer mode.
• LCD Backlight Level
Sets the LCD backlight brightness level. Maximum 25/Minimum 0.
• Auto Power up
If there is an AC power interruption, while Auto Power Up is enabled, the projector will resume operation in the same
state as it left off. If the lamps are on and an image showing when AC power is lost, the projector will automatically
power back up with the lamps on and an image will show when AC is restored.
• Auto Shutdown Enable
When Auto Shutdown Mode has been selected, and no projector activity has been seen for the activation timeout
period, the projector will enter a power saving mode in which the lamps will dim and the shutter will close. If this
condition persists for an additional time-out period, the projector will automatically go to Standby mode. The
presence of any activity within this combined interval will cancel Auto Shutdown and return the projector to normal
operation.
• Turn off Image after (min)