Cineversum Force one, Руководство пользователя

Страница: 79 / 100

10.0 MAINTENANCE
R599790 - FORCE Series User Manual 79
The high-intensity lamps and electronics rely on a properly functioning cooling system. Regular maintenance of the
cooling system is critical to prevent overheating and sudden projector failure and helps ensure reliable operation.
Ventilation
Vents and louvers in the projector covers provide ventilation, both for intake and exhaust. Never block or cover these
openings. Do not install the projector near a radiator or heat register, or within an enclosure. To ensure adequate
airflow around the projector, with a minimum clearance of 250 mm (10”) on the left, right and rear sides of the
projector from any walls or other obstructions. NOTE: Do not obstruct the air exchange to the projector.
Optional Filters
• Dust Air Filter
CHECK: Monthly
Check projector air dust filters, at minimum, every month.
Dust air filters (if fitted), should be replaced whenever the lamp is replaced or between 200-500 hours, depending
on use. A clogged air filter reduces air flow and can lead to overheating and failure of the projector.
Check monthly by inspecting its color through the side vent grille with a flashlight. Replace grey colored filters.
Leave the filters in their sealed packaging until ready for use.
• Fog Filter
Fog filters should be replaced after each use of the projector to a maximum of 20 hours. The life of the filter is
approximately 20 hours based on environmental conditions. Leave the filters in their sealed packaging until ready
for use. NOTE: The fog filters cannot be reused or they will clog up with oil and the projector will overheat and
shutdown.
Replace Filters:
• Unscrew the 2 captive screws at the top of each filter door. Allow the door to rest down and away from the
projector.
• Slide the air filter out and replace, vacuum or wash the filter. Wash using mild soap and water. NOTE: Dry the
filter before using.
• Insert the new or cleaned air filter(s).
• Secure the filter door by tightening the 2 captive screws loosened in Step 1.
Replacing filters
10.3 Maintenance of Optics
Optical (Excluding Lens)
Unnecessary cleaning of optics, increases the risk of degrading delicate coatings and surfaces. Only clean optics
when dust, dirt, oil, fingerprints or other marks are obvious and are causing performance problems.
Maintenance of optical components requires a qualified service technician. Inspect exposed optical surfaces
WARNINGS
Use only special, high efficiency approved filters.
This projector is not equipped with fan finger guards. Keep fingers away from the fan blades when replacing filter.
Always Power Down the projector and disconnect all power sources before servicing or cleaning.
Filter screws