Cineversum Force one, Руководство пользователя

Страница: 61 / 100

8.0 ADJUSTING THE IMAGE
R599790 - FORCE Series User Manual 61
NOTE: Only one user splash screen can be saved in the projector.
• OSD Transparency
Check this box if you want the OSD menu backgrounds to be transparent.
• Menu Type
Select the Basic or Advanced menu type from this list box. The Advanced menu setting will give the menu options.
The Basic menu setting will give a small number of the most frequently used menu items.
• Splash Screen
Choose which splash screen is to be used; the default or user downloaded splash screen.
• Cascading Menus
Enable or disable cascading menus. When disabled, a single menu level will be displayed on the OSD at a time.
Communications - Submenu
Defines and controls how single or multiple projectors are linked with each other and with a controlling device.
Serial Options - Submenu
• Baud Rate
Determines the speed of communication to and from the projector on the RS-232 or RS-422 links. The maximum
rate for the RS-232 is 115200; for RS-422 it is 19200. Set the baud rate to match that of your controlling device,
such as your PC. Refer to the documentation for the controlling device to determine the baud rate. In an existing
network of projectors, if you discover that a projector has a different baud rate, use the pull-down list and select the
correct baud rate using the ENTER key. Do not scroll this control with LEFT ARROW KEY or RIGHT ARROW KEY.
Serial communication is always eight data bits, no parity.
• Serial Flow Control
Determines whether software flow control or no flow control is used when transmitting and receiving data on the
serial port.
• Projector Address
Enter a three-digit number (such as “001”) to assign or change a number to the projector currently in use. If the
current projector already has a number assigned, that number will appear here (for example “004” in the menu
shown below. Numerical identity for projectors enables you to communicate with a single projector within a multiple-
projector application (see also PROJ key in, 3.1 Using the Remote Keypad or Built-In Keypad). If you make a
mistake in assigning or changing the projector number, press EXIT to cancel. NOTE: When multiple projectors are
being used and you want to adjust the color for individual projectors to create one seamless image, you must assign
different numbers for each projector to allow switching back and forth between projectors while adjustments are
being made.
• Network Routing
NOTE: Not applicable for stand-alone projectors or simple serial networks with only one type of controller and
linking.
Network Rooting List
Ethernet Settings
NOTE: Recommended for network administrators only.
• IP ADDRESS
Enter a valid and unique IP address for use on the network to which the projector is currently connected. This
address will overwrite any previous IP address such as the projector’s factory-defined default. It takes approximately
10 seconds for the projector to respond at its new address.
• TCP PORT
On some Ethernet networks, firewall restrictions may require that the port number of the projector be changed from
its default of 3002. If so, enter a new valid port number here. It is highly recommended not to use a port # below
1000, as these ports are typically reserved for and used by common IP applications.
• SUBNET MASK
1. Seperate
2. RS-232 and RS-422 Joined
3. RS-232 and Ethernet Joined
4. All Joined
- Networks do not communicate with one another
- Serial Networks are joined but Ethernet is isolated
- RS-232 and Ethernet are joined, but RS-422 is isolated
- Network communication travel all networks