Cineversum Force one, Руководство пользователя

Страница: 58 / 100

8.0 ADJUSTING THE IMAGE
58 R599790 - FORCE Series User Manual
on the average level of brightness in the scene, and the setting of this control. The brighter the scene the less
impact this control will have. It is often best to adjust the sensitivity and white compression together to find the
optimal settings.
• Copy From
This control allows you to copy the Dynamic Iris Settings from an existing profile to the current profile.
8.3 Configuration Menu
Use the Configuration menu to define general operating parameters and communications with other projectors and
equipment, and to access other advanced processing and image adjustments affecting overall performance. The
Configuration menu provides access to diagnostics, calibration tools and the Service submenu (password-
protected).
Configuration Menu
Language
Choose the available language to use in the projector’s menus. The change will take effect immediately.
Output Options - Submenu
• Screen Image Orientation
Select the on screen image orientation from Front, Rear, Front Inverted, and Rear Inverted.
• Output Resolution
Sets the output pixel resolution; default is the native resolution of the projector.
• Frame Locking
Select how the projector controls the output frame timing based on the input signal. When set to Framelock, output
image frames are locked to the input if possible. When Locked, the output is always locked to the primary input,
never the PIP image. Free Run sets the output to close to 60Hz for all sources.
NOTE: When switching to a new input with framelocking enabled, the image will appear black for a short duration
while the system locks onto the new input.
• Frame Delay
This control delays the output signal timing relative to the input signal timing by a fraction of a frame, and up to
several frames. The minimum latency can vary based on the amount of scaling applied to the image. When using
keystone or warping, an additional latency is required, depending on the amount of warp. The control is only
available when the input signal is frame locked. In free run mode, or in cases where the signal cannot be frame
locked, the minimum latency defined by the scaling and keystone/warp is applied to the signal.
• Free Run Frequency
This control sets the output video vertical frequency.
• HDMI Output Loop Source
This control is used to configure the HDMI output options. Selecting Direct Loop will directly pass-through the HDMI
input signals: on the same Twin HDMI Input Card, the Input1 signal is looped to Output1 and the Input2 signal is
looped to Output2. Selecting Main/PIP Loop will loop the Main & PIP video to the outputs, regardless from which
card these signals originate. The Main video signal is looped to Output1 and the PIP video signal is looped to
Configuration
1. Language
2. Output Options
3. Lens Settings
4. Power Management
5. Date & Time
6. Menu Preferences
7. Communications
English
8. Geometry & Color
9. Diagnostics & Calibration
10.Service
11.Option Card Settings
12.Dynamic Iris