7. ACCESSORY DESCRIPTION AND ASSEMBLY
7-1
7.1
Catalog No. 2522X Coolant Circulator
The Catalog 2522X Coolant Circulator is designed to provide enough coolant
to operate the Portaspec continuously for 8 hours without overheating the x-ray
tube. It now comes as a standard accessory with a new X Series Portaspec
®
.
The Coolant Circulator plugs into a dedicated software-controlled receptacle on the
back of the Portaspec, that can be configured to be
“Always On”
, circulating water
all of the time or
“Cycle With X-Rays”
, only on when x-rays are energized. It can
be used as a replacement to our Models 2511 or 2511X Circulators and can be
plugged directly into any Portaspec accessory receptacle.
7.2
Filling the Coolant Circulator
It has a three-gallon capacity and
comes with a submergible pump
with inlet filter, 8
’ of hose that
connects to the Portaspec and
one gallon of a Propylene Glycol
solution to add to distilled or
de-ionized water at the following
ratio:
3 Gal. (11.4 L) De-ionized
or Distilled Water
½ Gal. (1892 ml) Propylene Glycol
There is no flow requirement on the
Portaspec for hose connections as
the cooling circuit is a continuous
closed loop. A typical flow rate,
when connected to the Portaspec
is approximately 1 quart per minute.
The 2522X Coolant Circulator does not chill the water as chilled water could
lower the internal components below the dew point resulting in condensation.
This in turn, could damage internal components.
7.3
Coolant Circulator Technical Data
Operating Voltage
118 Volts AC, 50/60 Hertz
Current Draw
0.5 Amps
Weight
9 Pounds Empty / 25 Pounds Full
Capacity
3 US Gallons
Flow Rate
15 GPH @ 3’ Head
Important: Do not use ethylene glycol solutions
2522X Coolant Circulator
2522X Water Circulator
Image 7-1
Содержание 2501XBT
Страница 38: ...9 X SERIES TECHNICAL DATA 9 1 ...
Страница 40: ...APPENDIX ...