Chrysler IIIH, Инструкция по сборке

Страница: 27 / 100

7. With the engine right‐side‐up on the engine stand, inspect the deck of the block and threaded bores for the cylinder
head fasteners for any debris. Place the cylinder head gasket removed from the New Engine Tear Down on the
cylinder deck.
8. Clean and inspect the left & right side BHJ Cylinder Head Torque Plates MP‐3.6PSV6‐R‐AL‐T‐DID and place on the
engine block.
9. Clean and lubricate the cylinder head fasteners removed from the New Engine Tear Down using a lint free rag soaked
in EF‐411 to assure a light coating on the threads, by twisting the threads between folded sections of the rag.
(See Materials Section of the IIIH Engine Assembly Manual for suggested suppliers)
10. Install each fastener with the Special BHJ Hardened Spacer Type Washer in the Torque Plate and lightly engage the
threads by hand into the block.
11. Lightly seat each bolt following the proper sequence as outlined for each bank in View B.
12. Torque the fasteners as outlined in View B following the proper sequence for each bank in the following order;
a. All fasteners to 30 N∙m
b. All fasteners to 45 N∙m
c. All fasteners plus 70° (First Pass)
d. All fasteners plus 70° (Second Pass)
View B
13. Carefully lift the engine block and install into the Sunnen SV‐10 Hone taking care to clean the tilting table and tie bar
when setting the block in the hone. Carefully snug the tightening fixture while making sure the block is properly
aligned horizontally along the fixture inside the hone.
14. Insure the hone is properly set for the IIIH Honing Operations according to Section 4 Sheet 8.
Revision DRAFT Section 4
Mar‐16 Sheet 7
Cylinder Block Honing Prep
Torque Plate Installation