Christini AWD 450, Руководство по обслуживанию

Страница: 33 / 118

Page 32
Maintenance
SWINGARM/SHOCK LINKAGE SWINGARM/SHOCK LINKAGE SWINGARM/SHOCK LINKAGE SWINGARM/SHOCK LINKAGE
•
Raise the rear wheel off the ground by placing a work stand or equiva-
lent under the engine.
•
Check for worn swingarm bearings by grabbing the rear swingarm and attempting
to move the swingarm side-to -side.
•
Replace the bearing if excessively worn.
•
Check the shock linkage and replace any damaged needle bearings.
•
Disassemble, clean, and inspect the swingarm and shock linkage pivot bearing and
related seals every three races or about 7.5 hours of operation.
WHEELS/TIRES WHEELS/TIRES WHEELS/TIRES WHEELS/TIRES
•
Support the frame by the bracket under the engine, so that the front
wheel off the ground.
•
Grab the bottom of front suspension and rock the front wheel on both
sides to check whether the front wheel axle is loose.
•
Grab the rocker and rock the rear wheel on both sides to check whether
the rear wheel axle has problem.
•
Check the tires for cuts, embedded nails, or other damage.
•
Check the cold tire pressure (Remember to do it when the tire is cold).
•
Check the rims and spoke for damage.
•
Tighten all the loose wheel spokes and lock (valve nut)
Torque Specs Torque Specs Torque Specs Torque Specs
•
Tire pressure Front wheel :98kPa(1.0kgf/cm
2
,14psi)
•
Rear wheel:98kPa(1.0kgf/cm
2
,14psi)
•
Tools:Front wheel:Spoke wrench Rear wheel: Spoke wrench 6.6mm
•
Torque Front wheel spoke:3.68N.m(0.4kgf.m,2.7lbf.ft)
•
Rear wheel spoke:3.7N.m(0.4kgf.m,2.7lbf.ft)
•
Valve nut:13N.m(1.2kgf.m,9lbf.ft)