2-8
Solaria One/Solaria One
+
Service Manual
020-101039-02 Rev. 1 (06-2013)
Section 2: Adjust the Image
h. Tap
Activate
to activate the channel.
4. Display a RGB-12bit-Full Screen White test pattern:
3D Sync Input Mode
Specifies whether a specific frame of input data has left eye or right eye
data.
Select Use White Line Code (true and inverted) if you are using a single
3D input signal in which an embedded white line at the bottom of each
frame identifies left and right, and an additional separate 3D stereo sync
input at the GPIO port is not present. The bottom row of the left-eye sub-
field should be pure white for the left-most 25% of the pixel row and
pure black for the remainder of the row. The bottom row of the right-eye
sub-field should be pure white for the left-most 75% of the pixel row and
pure black for the remainder of the row.
Select Use Line Interleave for 3D source data only. When specified, the
ICP will de-interleave each line into the left image or right image in
memory as specified. Line interleave can be used with PsF 3D data (left
and right data for one field, then left and right data for second field).
L/R Display Reference
Specifies which frame of eye data to display during a specific display
frame. This signal is referenced to the display frame rate which is speci-
fied by the Frame Rate N:M.
Frame Rate N:M
Sets how many frames to display per number of frames that form one
complete image. Increase the display frame rate to reduce flicker from
your source(s).
L/R Display Sequence
Defines the frame order (L-R or R-L) required for 3D perspective. This
option only has meaning when the Frame Rate factor M is equal to 2. For
this case, 2 input frames of data are required to constitute a complete
frame of image data. This parameter tells the system which frames go
together to make a complete image.
NOTE
:
When using
Line Interleave
as the
3D Sync Input Mode
, ensure that
Left (L1R1 L2R2)
is selected.
3D Sync Polarity
Keeps 3D stereo sync output the same as input (true) or reversed
(inverted).
True
: 3D L/R sync output from GPO will match L/R sync input.
Inverted
: 3D L/R sync output from GPO will be the opposite of sync
input (left = right, right = left).
Dark Time
Creates a blank time interval between left and right frames to allow for
LCD shutter glasses, Z screen, or rotating 3D wheel to synchronize the
output. See Dark Time and Output Delay Notes below. Values between 0
and 65535 are accepted. Tap the
Launch Dialog
button
to enter the
dark time value.
Output Delay
The non-image time in Microseconds (
μ
). Offset 3D stereo sync output
in relation to dark time interval. Acceptable values are between -32768
and 32767 are accepted where a positive offset = delay and negative off-
set = start early. Tap
Launch Dialog
to enter the output delay value.
Phase Delay
The degree of reference between the left and right sync output. Values
between -180 and 180 are accepted. Tap
Launch Dialog
to enter the
phase delay value.
Field
Description
Содержание Solaria One
