3-6
Solaria One/Solaria One
+
Service Manual
020-101039-02 Rev. 1 (06-2013)
Section 3: Parts and Module Replacement
3.8
Remove the High Security Interlock Switch
The Lamp Door Interlock is located at the rear of the projector and is activated when you open the firewall
door.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
Remove the Top Lid on page 3-4.
4. Remove the high security lid. See
Remove the High Security and Light Engine Lid on page 3-5.
5. Disconnect the red and black leads from the switch.
6. Remove the two nuts securing the switch to the frame and then remove the interlock switch.
3.9
Remove the Cardcage Skin
This cardcage skin should never need to be removed unless it is damaged and requires replacement. From the
rear of the projector, the cardcage skin is on the right-side of the projector.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
Remove the Top Lid on page 3-4
4. Remove the card cage surround.
5. Remove the 2 screws above the cardcage.
6. Remove the card cage. See
Remove the Cardcage on page 3-25
.
Note:
When replacing the card cage, you must replace the anti-tamper label on the side of the cardcage
Содержание Solaria One
