Christie Solaria One, Руководство по обслуживанию

Страница: 57 / 88

Section 3: Parts and Module Replacement
Solaria One/Solaria One
+
Service Manual 3-29
020-101039-02 Rev. 1 (06-2013)
7. Remove the 4 screws securing the EMI shield to the top of the card cage and then remove the EMI shield
and set it aside.
8. Remove the 18 screws securing the backplane to the card cage.
9. Slide the backplane on an angle out of the cardcage so that it does not contact the cardcage.
When reinstalling the backplane, you must perform Marriage so you can continue to play encrypted con-
tent. See
Activate Marriage in the Solaria One or Solaria One
+
user manuals.
3.31 Fans
3.31.1 Remove the Anode Lamp Blower (Fan 1)
EXPLOSION HAZARD! Always wear protective safety clothing and a face shield when
performing service with the service safety shield removed and a lamp installed.
The anode lamp blower is located at the rear of the projector, behind the lamp access door.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Put on your protective clothing and face shield, and then unlock the lamp door.
NOTE:
The safety
interlock switch on the lamp door turns lamp power OFF and prevents it from being turned ON when the
door is open. The interlock wiring connects directly to the LPS.
NOTICE:
DO NOT place heavy objects on
the open rear access door.
4. Unlock and then open the lamp door.
5. Remove the 2 screws holding the blower to the anode firewall door.
6. Disconnect the anode blower harness.
7. Remove the anode blower through the lamp door opening.