Christie Solaria One, Руководство по обслуживанию

Страница: 45 / 88

Section 3: Parts and Module Replacement
Solaria One/Solaria One
+
Service Manual 3-17
020-101039-02 Rev. 1 (06-2013)
5. Loosen the 4 thumbscrews and remove the front LVPS compartment plate.
6. Pull the tray forward and out of the projector until the wire terminals are exposed.
7. Disconnect all of the wires that are attached to the LVPS and disconnect the stand by power supply AC
input connector.
8. Pull out the tray with the LVPS and then remove the 2 screws securing the stand by bracket.
9. Remove the tray with the LVPS and the stand by power supply from the projector.
10. Remove the 4 screws that secure the LVPS to the mounting plate.
11. Remove the screw securing the cable clamp.
12. Remove the clip securing the standby cable to the LVPS.
3.19 Remove the Projector Feet
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Prop up the appropriate end of the projector, or shift the projector off of the table or pedestal to create
enough clearance.
To remove the front feet, 6in. (15 cm) of clearance is required. To remove the rear feet, 9in. (23cm) of
clearance is required.
4. Remove the rear skin to remove the rear feet or remove the front skin to remove the front feet. See Remove
the Rear Skin on page 3-7 or Remove the Front Skin on page 3-4 .
5. Hold the top nut with a ratchet and then turn the locking nut on the foot to remove it.
6. Remove the foot.