Christie Solaria One, Руководство по обслуживанию

Страница: 51 / 88

Section 3: Parts and Module Replacement
Solaria One/Solaria One
+
Service Manual 3-23
020-101039-02 Rev. 1 (06-2013)
3.27 Remove the IMCB
This procedure is applicable to the Solaria One
+
projector only.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
Remove the Top Lid on page 3-4 .
4. Remove the high security lid. See Remove the High Security and Light Engine Lid on page 3-5 .
5. Disconnect the IMCB cable connector.
6. Loosen the captive screw.
7. Slide the IMCB toward the operator side of the projector to disengage the locking pins.
8. Lift the IMCB through the top of the projector.
3.28 Remove the Lens Mount
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the lens surround.
4. Remove the lens. See
Remove the Lens on page 3-14 .
5. Remove the top lid. See Remove the Top Lid on page 3-4 .
6. Remove the front skin. See Remove the Front Skin on page 3-4 .
7. Remove the plate between the lens mount and the blower intake.
8. Remove the light engine blower assembly. See
Remove the Light Engine Blower (Fan 4) on page 3-32.
9. Disconnect the IMCB connectors.
10. Remove the 4 lens mount screws. It might be necessary to adjust the horizontal or vertical position of the
lens to access the screws.
11. Disengage the IMCB harness assembly from the cable clamps and remove the assembly through the front
of the projector.
12. Remove the lens mount.