Christie Solaria One, Руководство по обслуживанию

Страница: 42 / 88

3-14 Solaria One/Solaria One
+
Service Manual
020-101039-02 Rev. 1 (06-2013)
Section 3: Parts and Module Replacement
4. Complete these fields:
5. Tap Save .
6. Tap Next .
7. Align the lamp. See Align the Lamp on page 2-10 .
3.15 Remove the Lens
1. Tap and hold the red power button on the TPC Main panel to turn the lamp and projector off.
2. Allow the lamp to cool for a minimum of 15 minutes.
3.
Disconnect
the projector from AC power or turn the circuit breaker off.
4. Remove the lens surround.
5. Install the lens cap and turn the lens clamp to the open position with a hex key.
6. If necessary, remove the 2 cap screws securing the lens to the lens mount using a hex key.
7. Pull the lens out of the lens mount and then install a small lens cap on the rear of the lens.
8. Remove the small rear cap from the new lens. Keep the front cap on.
9. Align the tabs on the lens plate with the lens mount. Insert the lens until it connects with the magnets on the
mount. When the lens contacts the magnetic plates it is seated correctly.
10. Secure the lens clamp by rotating it clockwise with a hex key.
11. Install the lens mount cap screws for added stability.
12. Replace the lens surround.
13. Remove the lens cap from the front of the lens.
Field Description
Type The lamp type.
Serial Number The lamp serial number.
Reason for Change The reason the lamp was changed.
Lamp Expiry (Hours) The number of hours the lamp can operate before replacement.
Hours Used The number of hours the lamp has operated before installation.