Christie Mirage S+, Руководство пользователя

Страница: 7 / 169

Section 2
Installation & Setup
Roadster/Mirage S+ User’s Manual
2-1
This section explains how to install and set up the projector. If you are familiar with the projector and want to quickly
set it up for temporary use, follow the
Quick Setup instructions below. For a more complete setup, follow the
instructions and guides covered in the remaining subsections.
NOTE: The lens is not installed for shipping. Refer to 4.5, Replacing the Lens.
Follow these steps for quick setup of the projector in a standard floor mount position.
Use either the remote or built-in keypad to work with the projected image.
Position the Projector
Set the projector at the expected throw distance (projector-to-screen distance) and
vertical position. See
2.3, Projector Position and Mounting and Appendix D . Make
sure that the projector is level from side-to-side (see Section 2.9, Leveling ).
Connect a Source
Locate the main input panel at the rear of the projector and connector your source to
the appropriate input:
◊
INPUT 1 (upper right area) – RGB input via BNC connectors.
◊
INPUT 2 ( left of BNCs) – digital or analog signals (DVI-I) from a computer.
◊
INPUT 3 (upper middle area) – composite video.
◊
INPUT 4 (upper middle area) – S-video.
◊
INPUT 5 (lower area of Roadster panel) – a factory-installed Dual SD/HD-SDI
module that can accept serial digital.
◊
INPUT 6 (lower area) – for optional input modules (see Appendix F ).
Connect to Power
The North American rated line cord is provided with each projector. Ensure
that you are using a line cord that meets the appropriate rating standards (CCC
for use in China, PSE for use in Japan).
Connect the projector’s line cord to the AC receptacle* at the lower rear corner on
the rear of the projector, and to proper AC—note the socket outlet must be installed
near the equipment and is easily accessible. Use
only the line cord provided with the
projector. Power requirements are shown below, with complete information in Section 6 .
* NOTE: The Roadster S+20K has an integral line cord.
2.1 Quick Setup
STEP 1
'
STEP 2
'
STEP 3
'