73
DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014)
Page 73 / 118
䖃
POWER UNIT2 BALLAST
Disassembling
Assembling
1) Disconnect CNLP2 and CNBL2 from the POWER
UNIT2 BALLAST.
2) Remove a screw to detach the POWER UNIT2
BALLAST from the ballast holder.
3) Detach the insulating covers from POWER UNIT2
BALLAST.
NOTE
Remember to detach the partitions and re-use them
with new POWER UNIT2 BALLAST. The service
parts do not include the covers.
1) Attach firmly the partitions on POWER UNIT2 BALLAST as below.
2) Put POWER UNIT2 BALLAST on the bottom ballast holder and screw down.
Clip the partition with the flap
Clip the partition with
the flap
POWER
UNIT2
Partition
Partition
Partition
POWER UNIT2
BALLAST
ballast
holder
Partition
POWER UNIT2 BALLAST
CNLP2
CNBL2 (5pin-6pin)
Wire CNLP2 as shown
CNPF2
Wire CNBL1 by passing it through this groove
T3x12 black screw
ATTENTION
Be careful not to confuse
CNBL2 (5Pin-6Pin) with
CNBL1 (5Pin-5pin).
Torque: 0.68
䡚
0.88N
䞉
m
Connect CNLP2, CNPF2 and CNBL2 and wire them as below.
Wiring
Clip the partition with
the flap
Clip the partition with the flap
POWER
UNIT2
BALLAST
Содержание DD1-WU80P
