63
DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014)
Page 63 / 118
NOTE:
Remove the LAMP EXHAUST DUCT before disassembling the LAMP HOUSEs.
Disassembling
1. Pull out the thermal sw.
2. Remove a screw to release the LAMP
?"*! !#
inside the LAMP HOUSE and detach it.
3. Remove the screw from the switch
device on the LAMP DOOR RELAY
PCB to remove it. Remember to
?"?&!#
the PCB.
Assembling
1. Screw down the LAMP SW. PCB on the LAMP SW.
METAL.
2. Check the wiring if it is properly prepared.
3. Screw down the LAMP HOUSE and LAMP lead
?"*! K
?"*! ## #
J*# ?"?&!
before. Make sure the totally covered with foil side of
the switch device faces the LAMP UNIT.
NOTE:
The thermal sw. with longer cable is TSW1 (CNTS1).
The one with shorter cable is TSW2 (CNTS2).
Wiring
""@!#\?%Q
Wire CNCS1 before attaching the LAMP1 HOUSE.
Check the arrangement of CNCS2 as shown below
before connecting it. Be sure to connect CNCS2 to
LAMP2 SW. PCB with taped side.
¾
@!#\?%Q
@>K*!&*?#&!H
LAMP1 HOUSE (L)
+©#
torque: 0.68~0.88N
·
m
TSW2, TSW1 (thermal sw.)
K+©#
torque: 0.39~0.59N
·
m
LAMP2 HOUSE (R)
CNLP1
CNLP2
K ?"*!
housing connector point LAMP
HOUSE side.
? ?"?&!
K!+©###
torque: 0.24~0.34N
·
m
LAMP HOUSE
<Common>
200mm
5mm
To LAMP2 SW. PCB
< CNCS2>
Pass the LAMP2 DOWN FAN cable
and CNCS1 through the clamp.
Power unit circuit case
Wrap with (fold between) a
piece of tape (W=20mm).
Содержание DD1-WU80P
