Christie DD1-WU80P, Руководство по обслуживанию

Страница: 64 / 150

62
DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014) Page 62 / 118
Disassembling
1. Disconnect all the harnesses from the LAMP DOOR RELAY PCB.
2. Remove a screw from the power unit
circuit case which secures the earth
cable CNGD2.
3. Remove 3 screws and lift the LAMP
EXHAUST DUCT to detach it.
4. Remove 3 screws and CNGD2, and
lift then slide the LAMP DOOR RELAY
PCB to detach.
Assembling
NOTE:
Be careful not to use wrong screw.
2 types of screws are used at this block.
1. Check the wiring if it is properly prepared.
2. Put the edge of LAMP DOOR RELAY PCB
under the ribs on the LAMP EXHAUST DUCT,
+
the PCB. Screw them down together with the
earth cable CNGD2.
•*›>K*”¶Ÿ>%&„%? +
œœK?>&”
duct.
4. Screw down the LAMP EXHAUST DUCT, and screw the end of CNGD2 on the power unit circuit
case as before.
5. Connect and wire all the cables as before.
Wiring
??"¢„!
? ##&@?"&!H?"›„„ #
¾ @!€#Q‰\!% (LAMP DOOR RELAY PCB)
•+!# Œ^'š©†'©©"Â
CNGD2
LAMP EXHAUST DUCT
•+'# Œ^'š©†'©©"Â
CNGD2
LAMP DOOR RELAY PCB
Rib Rib
CNGD2
Pass CNTS1 and CNTS through the hook,
and anterior two gaps between the bosses
in order of CNTS1 and CNTS.
Pass CNLDD through the hook, and put it
LAMP DOOR RELAY PCB side of 3rd boss.
Connect CNTS2 (TSW2).
Connect CNTS1 (TSW1) and CNTS.
There is no problem even if they are
connected to whichever.
Connect CNLDD.
LAMP DOOR RELAY PCB
Power unit circuit case
Power unit circuit case
Boss
Boss
60mm
< CNGD2>
Turn twice and
bind it with tape.