- 8 -
(1) Insert the unit into the panel cutout from the front of the panel.
(2) Screw lightly two provided mounting screws into the screw holes on left/right side (two locations in total) of the
recorder.
(3) Insert the hexagon heads of screws installed above into the round holes of brackets, (from the front) sliding
them as shown in the figure, press it firmly against the panel, and tighten them with the provided wrench or a
Phillips-head screwdriver. In addition, the tightening torque of the screw is 2Nm (for use of a Phillips-head
screwdriver).
* Note that the left bracket differs from the right one (Mounting must be performed by two persons).
2. Mounting condition
To avoid accidents, make sure to read and understand the following.
Industrial environment
Select a location distant from sources of electric field or magnetic field and without mechanical vibration or shock.
●
Overvoltage category ...... II
●
Altitude ........................... 2000m or less
●
Pollution degree .............. 2
●
Working place ................ Indoor
●
Short-term temporary overvoltage ...... 1440V
●
Long-term temporary overvoltage ....... 490V
Normal operating condition
●
Ambient temperature ·· 0 to 50
℃
(20 to 65%RH,non-condensing)
●
Ambient humidity ······· 20 to 80%RH,non-condensing(5 to 45
℃
)
●
Power voltage ··········· General specification: 100 to 240V AC
±
10%
●
Power frequency ······· General specification : 50/60Hz
±
2%
Atmosphere
●
For safety, avoid a location with corrosive gas, explosive gas, flammable gas and combustible gas.
●
Avoid a location with dust, smoke, or steam.
Mounting angle
●
Lateral tilting ············· 0 to 10°
●
Longitudinal tilting ······ Forward tilting: 0°Backward tilting: 0 to 30°
●
View angle ··············· -10 to +30°with the horizon as the standard
Angles other than the above affect the recording operation.
Indicator
View angle
About 30°
About 10°
Panel
Slide
!
Caution
