CF MOTO CF500-5, Руководство по обслуживанию

Страница: 85 / 254

4-12
z
Check thermostat pellet for cracks
z
Test the thermostat according to the following steps:
Pass a string between thermostat flange as illus-
trated on the right
Immerse the thermostat in a beaker with water.Make
sure that the thermostat is in the suspended position
without contact to the vessel.Heat the water by plac-
ing the beaker above a stove and observe the tem-
perature rise on a thermometer
Take the temperature reading from thermometer when
the thermostat valve opens
Thermostat Valve Opening Temperature:
68-74degrees,C
Tool:Thermometer
Keep heating the water to raise the water
temperature.When the water temperature reaches the
specified valve, the thermostat valve should have been
lifted by 3.5-4.5mm
Lift standard of thermostat valve:
water temperature 95degrees(C)
, ,
, ,
,
lift standard is
3.5-4.5mm
If thermotat valve opening temperature or thermostat
velve lift does not reach the standards,replace it.
z
Inatall thermostat:Reverse the removal procedure for
installation
Apply coolant to the rubber seal of thermostat
Install thermostat case.Tighten to the specified torque:
Tightening Torques:10N.m
Water Pump
Removal and Disassembly
z
Remove engine left side cover
z
Drain coolant
Note:Before draining coolant, check water pump for
oil or coolant leakage. In case of oil leakage, check
the water pump oil seal, O-ring. In case of coolant
leakage, check the water seal