CF MOTO CF500-5, Руководство по обслуживанию, Страница: 68 / 254

3-21
3.Checks & Adjustment
3 3
3 3
3
Inspection:
Inspect drive belt for wear and damage.
If any cracks or damages are found,
replace drive belt with a new one.
Inspect drive belt for width, if width is
out of service limit, replace drive belt with a new one.
Service Limit: 33.5mm
Tool: Vernier Caliper
Installation
Reverse the removal procedure for installation.
Pay attention to the following:
Insert drive belt, as low as possible,
between secondary sliding sheave and primary
fixed sheave.
Hold secondary sheave with a special tool and
tighten the nut to the specified torque.
Nut, Secondary Sheave: 115 N.m
Install primary sheave and nut. Hold the primary
sheave with a special tool and tighten the nut
to the specified torque.
Nut, Primary Sheave:115N.m
Turn primary sheave, until the drive belt is
properly seated and both the primary and
secondary sheaves rotate together smoothly
and without slipping.
Caution:
-Fit the drive belt with the arrow on the drive
belt points toward normal turning direction.
-The drive belt contact surface of the driven
face should be thoroughly cleaned.
Install CVT cover