CF MOTO CF125T-19 2003, Руководство по обслуживанию

Страница: 75 / 241

5-1
5 carburetor air filter secondary air inlet
5
Overhaul info
… … … … … … …
5-1 air filter assembly
… … … … … …
5-12
Failure diagnosis
… … … … …
5-2 air filter installation
… … … … … …
5-13
Carburetor disassembly … … 5-3 control valve disassembly … … … 5-14
Carburetor dismantling
… … …
5-4 small air filter disassembly
… … …
5-15
Carburetor assembly
… … … …
5-7 small air filter dismantling …
… …
.5-15
Carburetor installation
… … …
5-9 small air filter assembly
… … … …
5-15
Air filter disassembly … … … 5-10 small air filter installation … … … … 5-16
Air filter dismantling
… … … …
5-11 control valve installation
… … … …
5-16
Overhaul info
Caution
Note
Gasoline is highly flammable, therefore smoke and fire are strictly forbidden
in the work place. Special attention should also be paid to sparks. Gasoline
may also be explosive when it is vaporized, so operation should be done in a
well-ventilated place.
l Do not over twist or bend the cables. The twisted cables may cause poor operation.
l Check the installation position of o-rings, replace if necessary.
l Remove the drainage screw of the float bowl before dismantling and discharge
the gasoline in the carburetor with a container.
l To prevent impurities from entering into the engine from the intake side after the
carburetor is disassembled, cover the intake opening with a piece of cloth or
adhesive tape.
l In case the carburetor is stored over a month, be sure to discharge the gasoline in
the float bowl. Otherwise the gasoline in the float bowl will get aged and form the
glue component which may block the slow speed jet and cause unsteady idle
speed.
l For checking of the starting enriching device, please refer to Chapter 18.
Maintenance Norm
Item Norm
Fuel tank Capacity Full capacity 7.0L
Designated Mark BS26
Main jet #97.5
Slow speed jet #15
Mixture screw opening turning1-1/2 r
Float bowl fuel level 30
±
0.5mm
Carburetor
Idle speed 1600
±
100rpm