CF MOTO CF125T-19 2003, Руководство по обслуживанию

Страница: 63 / 241

3-15
3 Inspection, Adjustment
3
In case the density of CO/HC is more than the rated
value, turn the adjust screw and check the density of
CO/HC till the value is under the rated standard.
Special tool
Mixture screw adjusting tool: 07KMA-MS60101
Target value of CO density at idle speed:<4.5%
Remove the clamp of secondary air inlet pipe.
Check the idle speed and adjust if necessary.
Idle speed: 1600 ± 150r/min
Checking the throttle handle
Turn the throttle handle, and check if it can turn smoothly.
In case the turning of the throttle handle is not smooth
enough, Check if there is damage with the throttle cable,
or rust with the steel wire or any stickness with the
throttle handle.
Check the outer clearance of throttle handle.
Clearance: 2-6mm
Adjust the clearance when it is not in the rated range.
Remove the shield of the cable of throttle.
Loosen locknut of throttle cable, turn the regulator and
adjust clearance of throttle handle.
After adjusting, tighten locknuts and install throttle cable
shield.
Replace with a new throttle cable if the rated clearance
could not be reached by adjusting the regulator or if
there is still stickness with the throttle handle.