C.E.S. Model SDI-50 Manual, Level Adjustments
programmed number of rings that it's set for. When the caller hears
two short beeps the number of the mobile desired shouid be entered
followed with the "#". The "#" is used to terminate the mobile ANI
number and isn't sent out as part of the signalling.
If this switch is turned off, and Auto Answer is on, the interconnect
will still answer a call to allow remote programming, but won't allow
signalling.
( Aiso set *5 switchs 30, 31, 41 and 42 )
* 5 (tone) 12 (tone) 1 (tone) ;allow signalling
* 5 (tone) 12 (tone) O (tone) ;disallow signalling
6.5.3 "*" Reset of The Cali Limit Timer 1*5 13)
If turned on, this switch enables the mobile operator to reset the
Call Limit Timer by transmitting the "*" tone. If turned off, the
interconnect will time out after the time specified in the Call Limit
Timer (*1 4).
*5 (tone) 13 (tone) 1 (tone) ;allow reset
*5 (tone) 13 (tone) O (tone) ;disallow reset
6.5.4 Simplex Enable (*5 14)
This function enables the simplex use of the interconnect. If simplex
use is desired, turn this function on and turn *5 36 off. See section
6.2.1 for minimum requirements to enable the simplex mode.
* 5 (tone) 14 (tone) 1 (tone) ;enable simplex
* 5 (tone) 14 (tone) O (tone) ;disable simplex
6.5.5 Toll Restrict On The Ist Dialed digit (*5 15)
If the restricted numbers set by *5 00-11 are to apply to the first
dialed digit, then turn this switch on. If any number designated as a
restricted digit is dialed as the first digit of the phone number,
then the interconnect will disconnect and send the Error Message.
*5 (tone) 15 (tone) 1 (tone) ;restrict 1st digit
*5 (tone) 15 (tone) O (tone) ;don't restrict
6.5.6 Toll Restrict On The 2nd Dialed digit (*5 16)
If the restricted numbers set by *5 00-11 are to apply to the second
dialed digit, then turn this switch on. If any number designated as a
restricted digit is dialed as the second digit of the phone number,
then the interconnect will disconnect and send the Error Message.
Page # 27
