Carver Yachts 38 Super Sport, Руководство пользователя

Страница: 77 / 126

3827 • U2 3/10 7
P
roPulsion
s
ection
5
Gauge Maintenance
The gauges on the helm instrument panel should be protected from
the sun and weather when not in use. The gauges are not waterproof.
Protecting them from the elements prolongs their life.
NOTE:
Small beads of moisture (condensation) can form behind the glass bezel on
some gauges. This does not mean the gauge is defective. The Carver Limited
Warranty does not cover the replacement of gauges that are cosmetically
affected by condensation.
The gauges can be affected by static electricity that may build up on
their glass bezels. To help reduce the static electricity and thus improve
the gauges’ accuracy, periodically wash the bezels with warm water and a
mild liquid detergent.
Helm Controls
The helm controls allow you to engage the boat’s engines, control the
boat’s speed and engine RPMs, and control the direction in which the
boat is traveling.
Shift/Throttle Levers
Two shift/throttle levers allow you to both shift the engines from neutral to
forward or reverse and control the engine RPMs. With the levers in the
center position, the engines remain in neutral at their lowest RPM levels.
Lifting the levers above the neutral position shifts the engines to forward
and increases the RPM levels. Lowering the levers below the neutral
position shifts the engines to reverse and increases the RPM levels.
The shift/throttle levers are located on the starboard side of the steering
wheel. The outboard lever controls the starboard engine and the inboard
lever controls the port engine. The engines can be shifted/throttled
independently to improve maneuverability in tight quarters. Because your
boat has dual engines, it is recommended that you operate the engines at
the same speed while cruising. This reduces engine noise and vibration,
and improves engine efficiency.
Use the
engine synchronizer gauge to monitor the speed of each engine.
Adjust the shift/throttle levers so that the synchronizer gauge needle is
centered.
NOTE: Aligning the shift/throttle levers with each other does not necessarily mean the
engines are synchronized. To accurately synchronize the engines, rely on the
tachometers or the engine synchronizer gauge.
Engine Synchronizer
The optional engine synchronizer allows you to electronically and
mechanically interconnect both engine shift/throttle levers. This allows you
to increase and decrease engine speed using one lever, and keeps the
engines precisely synchronized. Refer to the OEM information for details
on operating the engine synchronizer.
Shift/Throttle - Engine Interface
For the standard mechanical controls, push-pull cables are used to connect
the shift/throttle levers to the engines. Refer to the OEM information for
details on adjusting and maintaining the shift and throttle control systems.
https://www.boat-manuals.com/