Carver Yachts 38 Super Sport, Руководство пользователя, Страница: 112 / 126

6 3827 • U2 3/10
W
interization and
S
torage
S
ection
8
10. Close the overboard discharge seacock.
11. On the DC Control Center, switch the Waste Pump circuit breaker OFF.
12. When you remove your boat from storage and prepare to use it again:
a. Pour 5 gallons of fresh water through the toilet.
b. Empty the waste tank as described in Section 4.
c. If the toilet uses seawater to flush, open the seacock that supplies
seawater to the toilet. Flush the toilet a few times to prime the sanitation
system.
d. Charge the waste tank by adding deodorizer. Use the brand of
deodorizer recommended by your Carver Dealer.
Grey Water Holding System
Before performing this procedure on the optional grey water holding
system, your boat should be pulled from the water. Winterize the grey
water holding system only after you have winterized the fresh water
system.
Refer to Section 4 - Grey Water Holding System for a description of your
boat’s grey water holding system.
There are two types of grey water holding systems: the standard system
and the overboard discharge system.
Standard Grey Water Tank System
1. Empty the grey water tanks as described in Section 4 - Grey Water
Holding System. Remove as much of the fresh water used in flushing
the tanks as possible.
2. On the Safety Breaker Panel, verify that the Shower Sump circuit
breaker is ON.
3. Pour 3 gallons of nontoxic recreational vehicle antifreeze through the
shower and each sink drain.
4. When you remove your boat from storage and prepare to use it again:
a. Pour 5 gallons of fresh water through the shower and each sink drain.
b. Empty the grey water tanks as described in Section 4 - Grey Water
Holding System.
c. Charge the grey water tanks by adding deodorizer. Use the brand of
deodorizer recommended by your Carver Dealer.
Overboard Discharge System
1. Empty the grey water tanks as described in Section 4 - Grey Water
Holding System. Remove as much of the fresh water used in flushing
the tanks as possible.
2. On the Safety Breaker Panel:
a. Turn the Accessory Battery master disconnect switch to the
ON position.
b. Switch the Main - One circuit breaker ON.
c. Verify that the Shower Sump circuit breaker is ON.
Open Closed
https://www.boat-manuals.com/