Wheel balancer 80-2000T. Operation Manual
p.35
35
9 TROUBLESHOOTING
9.1 Messages
The built-in fault detection system allows to promptly detect and precisely determine any
fault or malfunctioning.
In case of fault or incorrect usage the machine generates messages that are memorized
by the machine. The envelope icon activation in the information field indicates the occurrence of
messages.
To view the messages press the button
МЕНЮ
being in the state «New wheel»,
choose the option
Messages
. Look through the messages, write them down or remember.
Delete the messages by pressing the button
CLEAR
. In case of the machine malfunction
eliminate causes acting in accordance with table 9.1.
T a b l e 9.1
Code
Description
Remedy
F00
Unknown fault
Contact after-sales service office.
F01
Electronics are not tested
Contact after-sales service office.
F02
Shaft is not calibrated
Calibrate the shaft
F03
Imbalance sensors are not calibrated
Calibrate imbalance sensors
F04
Gauge is not calibrated
Calibrate gauge arm
F05
Motor is on, but shaft don’t rotate
To eliminate an external hindrance of rotation of a
shaft
Contact after-sales service office.
F06
Protection in the drive control block (an
overheat, shortcut, a high voltage/low
voltage
Switch off, then switch on wheel balancer. Try to start
motor. If the wheel balancer doesn’t work as
intended, provide normal operating conditions in
accordance with machine's specification
If result fails, contact after-sales service office.
F07
Noise on lines of the gauge of position of a
shaft
Only the PRECAUTIONARY MESSAGE. Working
capacity of the machine tool does not influence.
F08
Shaft position sensor fault
Contact after-sales service office.
F09
Not enough memory
Contact after-sales service office.
The error message in itself is not a guarantee case, and is only the tool for revealing of the reasons of
the malfunctions leading to wrong functioning of the machine tool.
