Wheel balancer 80-2000T. Operation Manual
p.22
22
6 EXAMPLES OF WHEEL BALANCING
6.1 Standard wheel balancing
An example of the standard car wheel balancing with clip-on weights is given below.
If the machine is not in the state «New wheel» change to this state. If it’s for example, in
the weight setting state, then press
NEW WHEEL
.
Press the key
STOP
for temporary brake actuation.
Mount the clean wheel on the shaft (Figure 6.1).
Figure 6.1 - Wheel mounting
a - enter dimensions
b - choose weight setting scheme
c - measure width of the
wheel by the calliper
Figure 6.2 - Input of standard wheel parameters
Enter dimensions. For this purpose place the first gauge arm to the rim (Figure 6.2a) and
hold it in this position until a signal is heard. Return the gauge arm to the initial position.
Possible weight setting schemes and width will appear on the display.
Choose the first scheme by pressing
ALU
and
ALU
buttons. Measure the
wheel width by the caliper, Figure 5.6. Enter width by pressing
WIDTH
and
WIDTH
.
Lower the cover for measurement. Wait for the wheel stop. Raise the cover. The
information on weights will be imaged on the display.
Set the weight of the given mass in "12 h" position on the left, as shown in Figure 6.3.
Press right key
SET
. Set the weight of the given mass in "12 h" position.
