Wheel balancer 80-2000T. Operation Manual
p.30
30
8 WHEEL BALANCER SETTING
8.1 Parameters setting
In this state it’s possible to see the current parameters values and to change them.
To enter the state «Parameters», being in the state «New wheel» it’s necessary to press
the button
MENU
then choose a menu item «Parameters» and press
EXECUTE
. The
display shows a list consisting of some items, Figure 8.1.
Figure 8.1
Press keys
UP
DOWN
, mark the item you need and press
CHANGE
.
Pressing the buttons
, change the parameter and press
OK
. Pressing the button
ESC
will restore initial parameters.
To exit the state «Parameters» with saving inputted changes press the button
EXIT
.
To exit the state without saving inputted changes press the button
ESC
.
Explanations of each parameter are given below.
8.1.1 Rounding: yes, no
If the rounding is OFF the weight mass is not rounded and will be displayed correctly.
If the rounding is ON the weight mass for truck car wheel will be rounded to values: 30 g,
50 g, 75 g, 100 g, 150 g, 200 g, etc.
If the rounding is ON the weight mass for motor car wheel will be rounded to 5 g. For
weights heavier than 60 the mass is rounded to 10 g. Besides, the mass «nulling» is performed.
Default value - yes.
8.1.2 Null threshold (car): 0…15
This item is for setting the null threshold for motor-car wheels.
If the rated weight mass is lower than the null threshold, then the indicator will display "0”.
For example, if the threshold is fixed equal to 10 grams, then with the weights mass from 1 to 9
grams the indicator will display “0”.
Nulling acts only if the rounding mode is ON.
Default value - 7.
