Wheel balancer 80-2000T. Operation Manual
p.24
24
a - input dimensions
b - choose weight setting scheme
Figure 6.6 - Input of alloy wheel parameters
Lower the cover for measurement. Wait for the wheel stop. Raise the cover.
The information on weights will be imaged on the display.
Set the weight of the given mass in "12 h" position on the left, as shown in Figure 6.3.
Press
SET
. Set the weight of the given mass in "12 h" position on the left, as shown in
Figure 6.7.
Figure 6.7 – Stick-on weights setting
Lower the cover for check measurement. Wait for the wheel stop. Raise the cover.
The information on weights will be imaged on the display. If the result is no equal «0 - 0»
set additional weights or change the position of the existing ones and repeat the check
measurement.
