Wheel balancer 80-2000T. Operation Manual
p.12
12
Figure 4.6
4.2.8 Set monitor in accordance with Figure 4.7:
fasten bracket 3 by screws M6 1;
fasten monitor to bracket 3 by screws M4 2;
plug DVI cable to monitor socket and socket 11 on machine body, shown on Figure 4.1.
4.2.9 Check the mains voltage conformity to the voltage indicated on the machine
nameplate and on monitor nameplate.
4.2.10 Connect monitor to socket 15 on machine body, shown on Figure 4.1, or to supply
mains, equipped with the mains socket with the grounding contact according to monitor
maintenance documentation.
4.2.11 Connect the power supply cable to the machine jack, located on the rear panel of
the machine body (Figure 4.1) and to the supply mains equipped with the mains socket with the
grounding contact.
Connecting machine and monitor to the supply mains without grounding is dangerous for the
personnel and may reduce the accuracy of measurements and damage the machine!
Figure 4.7 – Monitor setting
4.2.11 Fulfill the shaft balancing testing and balance standard wheel for testing after the
machine installation.
