Carlton SP5014TRX, Руководство пользователя

Страница: 69 / 160

SP5014TRX SERVICING CUTTER WHEEL
49
OPTIONAL:
Razor Cutter Wheel

If the machine is supplied with the optional
Razor cutter wheel, there are thirty-six (36)
teeth to a complete set. There are twelve
(12) Short Plow Bolt Bits and twenty-four
(24) Plow Bolt Bits.

DO NOT OPERATE A MACHINE
WITHOUT A COMPLETE NUMBER OF
TEETH IN THE CUTTER WHEEL
PROPERLY INSTALLED. EXCESSIVE
MACHINE VIBRATION WILL OCCUR
CAUSING PREMATURE BEARING
FAILURE AND EQUIPMENT
DAMAGE.

A locking pin is provided to hold cutter
wheel in position during tooth removal and
re-installation.

The locking pin will only lock in the deep
slots of the outer teeth. Line the slot up with
the locking pin slot and insert the pin to lock
position. The pin will need to be removed
and reinserted as wheel is rotated to change
remaining teeth. (Some early machines will
only lock on an outside 20° tooth.)

NEVER PLACE YOUR HAND ON THE
CUTTER WHEEL TO HOLD IT IN PLACE
WHILE CHANGING TEETH.

BE SURE TO REMOVE THE PIN BEFORE
OPERATING THE STUMP CUTTER.

The teeth do not require a setting gauge. The
only requirement is to be installed in the
proper direction and tightened to the proper
torque as discussed in the next section.

When replacing a cutter wheel tooth,
replace the tooth and nut as a set and use
anti-seize on the threads.