Carlton SP5014TRX, Руководство пользователя

Страница: 36 / 160

SP5014TRX MACHINE CONTROLS
16
TROUBLESHOOTING
SEE THE RADIO CONTROL MANUAL
FOR ANY OPERATING PROBLEMS
WITH THE RADIO RECEIVER &
TRANSMITTER
(Included in the back of this manual)

First check the batteries to make sure
they are providing enough power to
operate the transmitter.

There is a low battery light on the
transmitter, when it starts flashing you
have approximately 10 hours of
operation left.

Remove the back cover on the
transmitter. Remove old batteries and
replace with new batteries. The
transmitter operates using 4 AA alkaline
batteries.

Next, open the cover on the machine
control box. You will need to be able to
see the lights on the receiver to compare
to the trouble indicators on the receiver
diagnostic list in the radio control
manual. Check the light configuration
and compare it to the Receiver
Diagnostic list in the radio control
manual.

If status light on radio receiver is
flashing red, a fuse is blown. To change
a fuse, remove the receiver panel from
the cap and change the fuse. Inspect
wiring for short circuits (e.g. bare wires).
If problem re-occurs, call for service.
Push the receiver panel back up into the
cap until the tabs snap back into place.

Always replace the machine cover when
maintenance or troubleshooting is
complete. DO NOT RUN MACHINE
WITHOUT ALL GUARDS & COVERS
IN PLACE AND SECURED.
LOW BATTERY LIGHT
REMOVE THE BACK COVER TO ACCESS THE
BATTERIES – THERE ARE 4 SCREWS HOLDING IT IN
PLACE. THE BATTERY COMPARTMENT IS LABELED
FOR CORRECT BATTERY ORIENTATION.
COMPARE THE LIGHT CONFIGURATION ON THE
RECEIVER TO THE DIAGNOSTIC CHART IN THE RADIO
CONTROL MANUAL
REPLACE FUSE
REMOVE
COVER