Additional Information
SPX II Series
100
Operating Manual
03.17
11.4 Backfeed/delay
In continuous dispensing mode (IO dynamic continuous, IO static
continuous, IO photocell continuous) no optimised backfeed is
possible. Because of the fact when changing the print order, then the
current label in the offset sector is already printed from the old print
order.
With activated double cut no optimised backfeed is possible.
In the sector that is printed when preprint the following label, no
date/time variable should be existing, because this could be refreshed
before the next start impulse.
Peel off:
After printing the label, it is driven into the dispensing
offset and waited there, until the label was removed
(photocell) or a new start signal is given (IO dynamic).
Afterwards it is again backtracked to the beginning of
label and then the next label is printed.
Cutter:
After printing the label, it is driven into the cutter offset;
the label is cut and then backtracked immediately to the
beginning of label (if an operating mode with backfeed
is selected). Afterwards the next label is printed, if
necessary.
Tear off
edge:
After printing the last label of a print order it is driven
into the tear-off offset and the label res. labels can be
taken away. When starting a new print order, first it is
backtracked again to the beginning of label and then the
next label is printed.
If a following print order is available before driving into
the tear-off offset, then it is not driven into tear-off offset
but the following label is directly printed.
Peel off:
After printing the label it is driven into the dispensing
offset and then backtracked to the beginning of label
either immediately or after the set delay time. When
releasing a new start signal (IO dynamic) the next label
is immediately printed.
Cutter:
This is the same function as for 'backfeed standard' as it
is always backtracked immediately to the beginning of
label.
Tear off
edge:
After printing the last label of a print order it is driven
into the tear-off offset and then backtracked to the
beginning of label either immediately of after the set
delay time. When starting a new print order then the
next label is immediately printed.
If a following print order is available before driving into
the tear-off offset, then it is not driven into tear-off offset
but the following label is directly printed.
Backfeed operating
modes
Standard
Automatic