SPX II Series
Loading Media
03.17
Operating Manual
31
5.3 Loading Transfer Ribbon
NOTICE!
As for the electrostatic unloading the thin coating of the thermal
printhead or other electronic parts can be damaged, the
transfer ribbon should be antistatic.
The use of wrong materials can lead to print module
malfunctions and the guarantee can expire.
C
D
A
B
E
Figure 14
NOTICE!
Before a new transfer ribbon roll is loaded, the printhead must be
cleaned using printhead and roller cleaner (97.20.002). For
detailed information, please see page 78.
The handling instructions for the use of Isopropanol (IPA) must
be observed. In the case of skin or eye contact, immediately
wash off the fluid thoroughly with running water. If the irritation
persists, consult a doctor. Ensure good ventilation.
1. Open the print module cover.
2. Open printhead (C) by turning the red pressure lever (D)
anticlockwise.
3. Load the transfer ribbon roll (A) with outer winding onto the
unwinding roll (B).
4. Place an empty ribbon roll on the winding roll (E) and lead the
transfer ribbon below the printhead.
